480 GB 2.5-inch SATA mixed-use SSD, ordering codes MZ7L3480HELT-00A07 / -00B07
| Capacity | 480 GB |
|---|---|
| Interface | SATA |
| Form Factor | 2.5-inch 7mm |
| PCIe Version | Not applicable |
| NAND Type | TLC |
| Endurance (DWPD) | 3 |
| TBW | 2,628 TB |
| Sequential Read | 560 MB/s |
| Sequential Write | 530 MB/s |
| Random Read IOPS | 97K IOPS |
| Random Write IOPS | 60K IOPS |
| Power | 2.3 W |
| DRAM Cache | Yes |
| Power Loss Protection | Yes |
| Encryption | Opal 2.0 |
| Condition | New · Used |
Samsung PM897a 480 GB, 2.5-inch 7 mm SATA, catalogue code MZ7L3480HELT, ordering codes MZ7L3480HELT-00A07 and MZ7L3480HELT-00B07. 560 MB/s sequential read, 530 MB/s sequential write, 97K random read and 60K random write IOPS at 4 KB, 2,628 TBW — 3.0 drive-writes-per-day over five years — on Samsung 3-bit TLC V-NAND, with TCG Opal 2.0 and capacitor-backed power-loss protection. Stocked new or as tested pulls with a 1-year warranty from us.
This drive exists because the same specification ships under two model families, and the difference between them is harder to see than it should be. “PM897a / PM897” is a single product line with one set of numbers; inside that line there are two build codes and three ordering suffixes, and a mixed pallet will contain both. This page is about the a build and what it does and does not change.
Put the two 480 GB parts side by side and the published figures are identical: 560/530 MB/s, 97K/60K IOPS, 95/90 consistency, 105/30 µs, 2,628 TBW at 3.0 DWPD. What differs is the build code in the model number — HELT on this part against HBLT on the earlier PM897 build — and the ordering suffix that follows it, -00A07 or -00B07 here against -00B7C there. The a-build also groups its codes differently: only 480 GB carries HELT, the 960 GB member carries HELA, and the two largest capacities share HENA — three codes across four capacities, where the earlier build used two.
Samsung does not publish what changed between the two builds, and this page will not invent a reason. What is documented is that the specification did not: endurance, IOPS, latency, form factor and interface are the same numbers in the same table. For a buyer the practical consequence is that either build satisfies the same requirement, and the build code matters for firmware management and warranty records rather than for sizing.
The suffix matters for a different reason. -00A07 and -00B07 are two ordering codes for the same a-build drive, and both appear on parts in circulation; a platform that pins firmware to a specific code should say so on the PO, and we will match it. A PO written against the older -00B7C code is a different line item even though the drive underneath performs identically.
| Product family | Samsung PM897a (V-NAND SSD, data centre / mixed-use) |
|---|---|
| PN | MZ7L3480HELT (catalogue code) |
| Ordering code | MZ7L3480HELT-00A07 / MZ7L3480HELT-00B07 |
| Capacity | 480 GB (512-byte sectors, decimal capacity) |
| Form factor | 2.5-inch, 7.00 mm (100.20 × 69.85 × 7.00 mm, max 70 g) |
| Interface | SATA 6 Gb/s, Serial ATA 3.3, ATA/ATAPI ACS-4 |
| NAND | Samsung V-NAND, 3-bit (TLC) |
| Sequential read / write | 560 MB/s / 530 MB/s (128 KB, QD32) |
| Random 4 KB (QD32) | 97K IOPS read / 60K IOPS write |
| Random 8 KB (QD32) | 57K IOPS read / 40K IOPS write |
| IOPS consistency | 95% read / 90% write at 4 KB, sustained |
| Latency and QoS | 105 µs read / 30 µs write at QD1; 99.99th percentile 0.2 ms read, 0.05 ms write at QD1; 0.6 ms and 0.7 ms at QD32 |
| Endurance | 2,628 TBW — 3.0 DWPD over five years (TBW = DWPD × 365 × 5 × capacity) |
| Power | Active read 2.3 W; active write 3.0 W; idle 1.4 W (DIPM off); supply 5 V ±5% |
| Power-loss protection | Yes — capacitor hold-up transfers cached DRAM data to flash on failure; no hold-up time published |
| Data security | AES-XTS 256-bit encryption engine, TCG Opal 2.0 compliant |
| Features | TRIM, NCQ to depth 32, S.M.A.R.T., end-to-end data integrity, RoHS |
| Reliability | MTBF 2.0 million hours; UBER 1 sector per 1017 bits read |
| Environmental | Operating 0 °C to 70 °C (case); non-operating −40 °C to 85 °C; humidity 5–95% non-condensing |
| Code | Type | Condition | Quote |
|---|---|---|---|
| MZ7L3480HELT | Catalogue code | New / used | Enquire |
| MZ7L3480HELT-00A07 | Ordering code | New / used | Enquire |
| MZ7L3480HELT-00B07 | Ordering code | New / used | Enquire |
All three strings describe one 480 GB 2.5-inch 7 mm SATA drive with 2,628 TBW. The catalogue code is what a catalogue or an asset register indexes on; the two ordering codes are what a PO line and a warranty claim are written against. They are not capacity variants and not endurance grades — a -00A07 unit and a -00B07 unit are the same drive with different customer or firmware identity.
Where this gets practical is in a mixed fleet. If a platform team pins a firmware baseline, it needs to know which ordering code is in the chassis, and the only place that is recorded is the label and the PO. Tell us the code you need and we will select against it; if the platform does not care, either code will do and we will ship from the batch in hand.
The letter invites an assumption that is worth correcting, because the same letter means different things in different Samsung lines. On the read-intensive side, the PM893a at 480 GB is materially slower to write than the PM893 it replaced: 360 MB/s against 520, and 17K random write against 29K. That is a real step down, and anyone who learned the naming rule from that comparison would expect the same here.
It did not happen on this part. The PM897a at 480 GB holds the full 530 MB/s and 60K IOPS of the specification it inherits, and the endurance is unchanged at 2,628 TBW. The reason is not documented by Samsung, but the outcome is measurable and it is the number that matters: the a-suffix on the mixed-use line is a build identity, not a de-rating. Buying it does not mean buying a slower drive.
What it does mean is that the two builds should not be mixed inside one array without checking firmware. Both perform the same on paper and both carry the same endurance, so a mirror built from one of each is not a capacity mismatch — but a fleet that tracks firmware by model number will see two models where it expected one.
2,628 TB over five years is 1.44 TB of writes every day. Written flat out at 530 MB/s the rating would last about 57 days, so the ceiling is finite, but nothing that fits on 480 GB writes at 530 MB/s for two months. The daily allowance is the figure to plan against, and 1.44 TB covers a journal, a write-back cache, a continuously rewritten metrics store or a mirrored boot pair with room to spare.
The comparison that decides most 480 GB purchases is against the read-intensive grade, and it is not close: the PM893 at 480 GB carries 876 TBW, exactly a third of this budget, at 1.0 DWPD. Buying this drive for a volume that is mostly read spends money on endurance that is never consumed; buying a read-intensive drive for a volume that is rewritten daily is how a drive reaches its rated end of life in year two.
The 60K random-write figure is what separates it from every other 480 GB SATA drive in the catalogue, including the MLC parts. The SM883 at 480 GB carries the same 2,628 TB — identical endurance — but writes 27K random IOPS against 60K here, and 520 MB/s sequential against 530. On a queue, the difference is a factor of two; on a sequential copy, it is 10 MB/s.
| Model | Capacity | Sequential read / write | Random 4K read / write | Endurance | Class |
|---|---|---|---|---|---|
| PM897a 480 GB | 480 GB | 560 / 530 MB/s | 97K / 60K IOPS | 2,628 TB (3.0 DWPD) | Mixed-use |
| PM897 480 GB | 480 GB | 560 / 530 MB/s | 97K / 60K IOPS | 2,628 TB (3.0 DWPD) | Mixed-use, earlier build |
| SM883 480 GB | 480 GB | 540 / 520 MB/s | 97K / 27K IOPS | 2,628 TB (3.0 DWPD) | Mixed-use, MLC |
| PM893a 480 GB | 480 GB | 560 / 360 MB/s | 97K / 17K IOPS | 876 TB (1.0 DWPD) | Read-intensive |
| PM893 480 GB | 480 GB | 550 / 520 MB/s | 98K / 29K IOPS | 876 TB (1.0 DWPD) | Read-intensive |
| PM883 480 GB | 480 GB | 550 / 520 MB/s | 98K / 24K IOPS | 683 TB (0.78 DWPD) | Read-intensive |
| PM863a 480 GB | 480 GB | 520 / 480 MB/s | 97K / 16K IOPS | 683 TB (0.78 DWPD) | Read-intensive |
The first two rows are the point of this page: same numbers in every column, different build. If both are on the shelf, the choice is about firmware identity and price rather than performance. The third row is the last MLC drive at this capacity, and it is the one place where the older technology still has an argument — equal endurance, lower sequential figures, half the random write.
Below that the table splits by grade rather than by generation. The four read-intensive rows carry between 683 and 876 TBW, a quarter to a third of this drive's budget, and their random read is a match or slightly better. They are the right purchase for a boot volume that is read for five years and the wrong one for anything continuously written.
Every drive carries a 1-year warranty from us against defects in workmanship and function. Verified faulty units are replaced or refunded and we cover return shipping. Stock is held in both new and used condition; the condition you order is confirmed before dispatch, and used units are pull-tested rather than untested lots. Stock is held in our own warehouse and normally dispatches within three to seven working days, with tracking issued at dispatch.
This capacity is quoted rather than listed, because price moves with condition, quantity and batch. Send the quantity, the condition you need, the platform the drives are going into and — if it matters to your firmware baseline — which ordering code you need, and you will get a quote with lead time the same working day. Matched pairs for mirroring are selected from a single batch where stock allows, including build code, firmware revision and wear level.
Tell us who you are — we reply within one working day with a firm quote, stock status and lead time. Volume discounts available.
15.36 TB E1.L 1U long ruler NVMe SSD, PCIe 4.0, ordering code MZEL215THBLA-00AMV
7.68 TB E1.S 1T NVMe SSD, PCIe 4.0, ordering codes MZCL27T6HBLA-00AMV / MZTL27T6HBLA-00A07
3.84 TB E1.S 1T NVMe SSD, PCIe 4.0, ordering codes MZCL23T8HCLS-00AMV / MZTL23T8HCLS-00A07
1.92 TB E1.S 1T (9.5 mm) NVMe SSD, PCIe 4.0, ordering code MZCL21T9HCJR-00AMV