8 GB DDR4-2133 PC4-17000 ECC registered RDIMM, 2Rx8, 1.2 V, 288-pin; sixteen ordering codes under the DB0 and EB1 die revisions
| Capacity | 8 GB |
|---|---|
| Memory Type | DDR4 |
| Speed | 2133 MT/s |
| Form Factor | RDIMM |
| Rank | 2Rx8 |
| ECC | ECC |
| Voltage | 1.2 V |
| Module Height | Standard |
| Condition | New · Used |
Samsung 8 GB DDR4-2133 ECC registered RDIMM, two ranks of x8 devices on a standard 288-pin registered module at 1.2 V. Rated PC4-17000 with CAS latency 15, 14.06 ns at the 1,066 MHz clock, and 17.1 GB/s peak per 64-bit channel.
The 43 in the part number is the device width: x8, not x4. Eight gigabytes from x8 devices needs eighteen of them, and because each rank holds nine, that makes two ranks rather than one. So this is the 2Rx8 version of the 8 GB DDR4-2133 module — same capacity, same speed, same device count as the 1Rx4 part on its own page, but a different rank geometry, which is what a population guide counts.
It is supplied under two die revisions, M393A1G43DB0 and M393A1G43EB1, and sixteen ordering codes in total. Both revisions are the same module electrically; the code on the BOM decides which one ships. The table further down lists all of them so an exact code can be matched without eight near-identical pages competing with each other.
| Part number | M393A1G43DB0-CPB and M393A1G43EB1-CPB — two die revisions of the same module (catalogue codes M393A1G43DB0, M393A1G43EB1) |
|---|---|
| Capacity | 8 GB per module, single module |
| Organisation | 2Rx8 — two ranks of x8 devices, nine per rank, eighteen devices for the two 72-bit paths |
| Speed | DDR4-2133, PC4-17000, 2,133 MT/s, 17.1 GB/s peak per 64-bit channel |
| Timings | CL15 at 1,066 MHz, 14.06 ns; JEDEC 2133P bin |
| Voltage | 1.2 V nominal |
| Form factor | 288-pin RDIMM, standard height 31.25 mm, bare PCB with no heatspreader |
| Register | On-module register buffers the command and address bus, so the module needs a controller that supports registered memory |
| Error handling | ECC across the 64-bit data path, plus parity on the registered command and address path |
| Manufacture | Samsung; assembly site and date code vary by production run and are printed on the module, not fixed by the part number |
| Condition | New and tested pulls, both stocked |
Three fields on this label come from the part number: capacity, the 2Rx8 organisation and the PC4-17000 bin, whose P letter fixes CL15. The rest describe the run it came from — revision letters, SPD level and the YYWW date all move between runs — so they are decoded below rather than printed as facts.
| Printed as | Means | Why it decides a purchase |
|---|---|---|
| 8GB | Capacity of this one module | Sets how many slots are needed for the target memory size, and it is the one number a platform setting cannot change |
| 2Rx8 | Two ranks, x8 device width | Two ranks per module is what the population guide counts; at two modules per channel that is four ranks in the channel, which is where derating starts |
| PC4-17000P | DDR4-2133, JEDEC bin P, which is CL15 | The bin letter is the timing grade, not a vendor code; a listing that says PC4-2133 without the letter has not specified latency |
| -R | Registered, not unbuffered | An unbuffered module of the same capacity looks similar from above and will not post in a registered-only board |
| DB0 / EB1 | Die revision, the block between the density field and the speed code | Same capacity, rank and speed either way; the revision records which component generation the module was built from |
| CPB0 … CPBQ | Ordering tail, the characters after the speed block | The field a BOM or an invoice names. It does not change capacity, rank or speed, all of which are fixed earlier in the code |
| Raw card block | Revision and raw card design, the characters before the SPD number | Matters where a platform qualification list names a specific raw card for a slot population |
| SPD revision | Two-digit JEDEC SPD revision level | Older firmware reads lower revisions more reliably; this generation is old enough that the difference still shows up |
| YYWW | Date code, year and week | Age of the stock; on pulls it is the first evidence of how long the module has been in service |
A rank is exactly 72 bits wide — 64 for data, 8 for check — and an x8 device carries eight, so nine devices fill it. 8 GB therefore needs eighteen devices and two ranks on this 2,133 build; the 1Rx4 version reaches the same capacity with the same eighteen devices as one rank of x4 parts.
Guides budget ranks, not modules. Two of these at 2,133 already make four ranks in a channel, which is the population where the clock usually steps down; the 1Rx4 build of the same capacity would sit at two ranks in the same slots.
What 2Rx8 buys in exchange is availability and price. It is the common 8 GB DDR4-2133 build, because it can be made from 4 Gb x8 dies rather than the wider or denser parts the single-rank variants need, and it is what most of the installed base actually has inside it.
Eight gigabytes per slot at the base DDR4 speed is the workhorse of the first two DDR4 server generations. One module per channel on an eight-slot board is 64 GB, twelve slots is 96 GB, sixteen is 128 GB and twenty-four is 192 GB. At one module per channel a 2Rx8 population is two ranks per channel, within every guide's limit, so the rated 2,133 is normally held.
It is also the like-for-like replacement. A machine built with 8 GB 2Rx8 parts expects two ranks per slot at 2,133; dropping in a 1Rx4 module of the same capacity changes that count without changing the label — the kind of substitution firmware notices and benchmarks eventually explain.
Count the slots before choosing a module: an 8 GB 2Rx8 population at 2,133 gives 64 GB across eight slots, 96 GB at twelve, 128 GB at sixteen and 192 GB at twenty-four. The same sixteen slots filled with 32 GB parts is 512 GB — this module is the balanced line, not the dense one.
Generation and signal type come first — DDR3 does not fit, unbuffered does not post in a registered board, DDR5 uses another notch — and only then do the variables matter: for this 2,133 2Rx8 module they are capacity, rank and the clock the host applies.
Mixing a 2Rx8 module with a 1Rx4 module of the same capacity is the trap on this page. Both are 8 GB at 2,133 and both will post, but the channel now carries three ranks instead of two or one, and the controller interleaves across them on the slower pattern. Where a guide publishes rank limits per channel, that combination is outside the table it was written for.
Speed is the quieter variable. Drop a 2,133 2Rx8 module among faster parts and the channel simply runs at the slower bin, with nothing in the log to announce it. Matched modules per channel, then a second matched set, keeps rank, revision and speed uniform.
2,133 is the floor every DDR4 registered platform accepts, so a 2Rx8 module at this speed never needs a compatibility argument — it runs at its own bin and sets the ceiling. Three pages worth reading beside it:
Compatibility is not the question with this 2,133 2Rx8 part — clock and population are. Treat the 2,133 figure as the module's ceiling and the platform guide as the authority on what it will run at.
Every code in the table below is the same 8 GB 2Rx8 module at 2,133 MT/s. The block before the dash fixes family, device width and die revision; the dash and its tail are what a purchase order or an invoice actually names, and Samsung publishes no public decoder for them.
On the two revisions: the same density, speed, rank and component count are listed for DB0 and EB1 by every source checked, and no functional difference is published between them. They are successive component generations of one design, which is why they are sold here as one line with two build families rather than two products. Where a BOM names one of them, quote that family; where it names neither, either revision satisfies the line, and matched revision per channel is the pattern that behaves predictably.
| Code | Build | Build tail | Condition | Quote |
|---|---|---|---|---|
| M393A1G43DB0 | DB0 catalogue | Family code without a speed block; the P build listed here is the PC4-17000 / 2,133 MT/s one | New / used | Enquire |
| M393A1G43DB0-CPB | DB0 | Base ordering code, no tail appended | New / used | Enquire |
| M393A1G43DB0-CPB0 | DB0 | 0 | New / used | Enquire |
| M393A1G43DB0-CPB00 | DB0 | 00 | New / used | Enquire |
| M393A1G43DB0-CPB0Q | DB0 | 0Q | New / used | Enquire |
| M393A1G43DB0-CPB0QS | DB0 | 0QS | New / used | Enquire |
| M393A1G43DB0-CPB20 | DB0 | 20 | New / used | Enquire |
| M393A1G43DB0-CPB2Q | DB0 | 2Q | New / used | Enquire |
| M393A1G43DB0-CPBQ | DB0 | Q | New / used | Enquire |
| M393A1G43EB1 | EB1 catalogue | Family code without a speed block; the P build listed here is the PC4-17000 / 2,133 MT/s one | New / used | Enquire |
| M393A1G43EB1-CPB | EB1 | Base ordering code, no tail appended | New / used | Enquire |
| M393A1G43EB1-CPB0 | EB1 | 0 | New / used | Enquire |
| M393A1G43EB1-CPB00 | EB1 | 00 | New / used | Enquire |
| M393A1G43EB1-CPB0Q | EB1 | 0Q | New / used | Enquire |
| M393A1G43EB1-CPB0QS | EB1 | 0QS | New / used | Enquire |
| M393A1G43EB1-CPB20 | EB1 | 20 | New / used | Enquire |
| M393A1G43EB1-CPB2Q | EB1 | 2Q | New / used | Enquire |
| M393A1G43EB1-CPBQ | EB1 | Q | New / used | Enquire |
The M393A1G43DB0-CPB line carries one year of cover from dispatch, new or pulled, recorded per part number and batch. Every pull is tested as a matched set before packing and that result ships with the module; orders leave in three to seven working days, two pieces minimum.
Pricing here is per enquiry, not per page. Send the exact 2,133 2Rx8 code, the quantity and the platform and the answer arrives the same working day; a set quote beats piecemeal orders because the channel population can be validated first.
Tell us who you are — we reply within one working day with a firm quote, stock status and lead time. Volume discounts available.
16 GB DDR4-2933 PC4-23400 ECC registered RDIMM, 2Rx8 on eighteen 8 Gb x8 packages, 1.2 V, 288-pin; six ordering codes under M393A2K43CB2-CVF with BY, CO, BQ, C0 and GQ tails
16 GB DDR4-2400 PC4-19200 ECC registered RDIMM, 2Rx8 on eighteen 8 Gb x8 packages, 1.2 V, 288-pin; eighteen ordering codes under the M393A2K43BB1 and M393A2K43CB1 revisions
16 GB DDR4-2133 PC4-17000 ECC registered RDIMM, 2Rx8 on eighteen 8 Gb x8 packages, 1.2 V, 288-pin; nine ordering codes from M393A2K43BB1-CPB through the CPBQ tail
16 GB DDR4-2666 PC4-21300 ECC registered RDIMM, 2Rx8 on eighteen 8 Gb x8 packages, 1.2 V, 288-pin; six ordering codes under M393A2K43BB1-CTD with 6Q, 6Y, 7Q, 7Y and 8Q tails