8 GB DDR4-2133 PC4-17000 ECC registered RDIMM, 1Rx8, 1.2 V, 288-pin; eight ordering codes from M393A1K43BB0-CPB0 to -CPBQ
| Capacity | 8 GB |
|---|---|
| Memory Type | DDR4 |
| Speed | 2133 MT/s |
| Form Factor | RDIMM |
| Rank | 1Rx8 |
| ECC | ECC |
| Voltage | 1.2 V |
| Module Height | Standard |
| Condition | New · Used |
Samsung 8 GB DDR4-2133 ECC registered RDIMM with nine x8 devices on a single rank, at 1.2 V on a 288-pin registered module. The bin is PC4-17000P, CAS latency 15 at the 1,066 MHz clock, which works out to 14.06 ns, and 17.1 GB/s peak per 64-bit channel.
Count the silicon rather than reading the label. This module is 72 Gb of DRAM: sixty-four bits of data plus eight of ECC, one x8 package behind each bit, so nine packages of 8 Gb. The 1Rx4 module of the same capacity holds the same 72 Gb cut the other way — eighteen 4 Gb packages, two in parallel behind every bit. Both are one rank. What differs is the number of solder joints and the capacitance the controller has to drive through them.
Eight ordering codes are stocked, all under the catalogue code M393A1K43BB0, and they sit in one table near the foot of the page. Nothing in the tail of a code alters the module; the tail is what a purchase order happens to name.
| Part number | M393A1K43BB0-CPB, with the eight ordering codes listed under Ordering codes (catalogue code M393A1K43BB0) |
|---|---|
| Capacity | 8 GB per module, single module |
| Organisation | 1Rx8 — one rank of nine x8 devices, 72 Gb in total: eight bytes of data per bit position plus the check byte, on 8 Gb components |
| Speed | DDR4-2133, PC4-17000, 2,133 MT/s, 17.1 GB/s peak per 64-bit channel |
| Timings | CL15 at 1,066 MHz, 14.06 ns; JEDEC 2133P bin |
| Voltage | 1.2 V nominal |
| Form factor | 288-pin RDIMM, standard height 31.25 mm, bare PCB with no heatspreader |
| Register | On-module register buffers the command and address bus, so the module needs a controller that supports registered memory |
| Error handling | ECC across the 64-bit data path, plus parity on the registered command and address path |
| Manufacture | Samsung; assembly site and date code vary by production run and are printed on the module, not fixed by the part number |
| Condition | New and tested pulls, both stocked |
Nine characters of a Samsung part number decide everything a buyer cares about, and the remainder describes the batch. The table separates the two, so nothing printed on a sticker is presented here as a guarantee.
| Printed as | Means | Why it decides a purchase |
|---|---|---|
| 8GB | Capacity of this one module | Multiplied by the slot count it gives the machine total, and no firmware setting can change it |
| 1Rx8 | One rank, x8 device width | Nine packages on the bus instead of the eighteen an x4 build of the same capacity needs, which is the lightest load a 72-bit rank can present |
| PC4-17000P | DDR4-2133, bin P, which is CL15 | Without the bin letter a listing has named a frequency but not a latency, and the two prices are not the same |
| -R | Registered, not unbuffered | Same outline, different signalling; an unbuffered module will not post in a board that expects a register |
| BB0 | Die generation and raw card revision | Records which component generation the board was built from; capacity, rank and speed are unaffected by it |
| CPB0 … CPBQ | Build suffix after the speed block, one to three characters | What a BOM or an invoice quotes. Speed and organisation were settled earlier in the code and cannot move here |
| Raw card block | Raw card design revision, printed ahead of the SPD number | Only matters when a platform's qualified list names one specific raw card for a slot population |
| SPD revision | Two-digit JEDEC SPD revision | Old firmware reads low revisions more reliably, and DDR4-2133 boards are old firmware by now |
| YYWW | Date code, year and week | On a pull this is the only honest indicator of how long the module has been in a live chassis |
A rank is 72 bits wide and a x8 device supplies eight of them, so nine devices fill it exactly and no more are needed. The x4 variant reaches the same width with eighteen devices, each supplying four bits, paired two-deep behind every bit position. Electrical load follows the package count: nine loads per rank against eighteen.
How much that matters depends on the clock. At 2,133 the bit period is wide enough that eighteen loads per rank still close timing on most boards, which is why x4 single-rank was the default here for years. Push the same channel to 2,666 and the margin shrinks until the package count starts deciding whether a population holds its rated speed — the reason single-rank x8 parts became the safe answer later in the DDR4 cycle rather than at the start of it.
So on this module the single rank is the interesting property, not the device width. One rank of nine is the least a channel can be asked to carry at 8 GB per slot, and at 2,133 that headroom is mostly insurance rather than a requirement.
An 8 GB x8 rank needs 8 Gb components. DDR4-2133 shipped in 2014 on 4 Gb silicon, so the first 8 GB modules at this speed were two ranks of eighteen 4 Gb devices, and that build is still the common one in the secondary market. Single-rank 8 GB at 2,133 only became economic once 8 Gb dies were in volume, which puts it in later production runs and in OEM configurations that specified it for population reasons.
That history has a practical consequence at goods-in. Where a BOM says 1Rx8, a 2Rx8 module of the same capacity will post and will run, but the channel now holds twice the ranks the platform was designed around, and the difference surfaces later as a derate on a fully populated board rather than as a failure on the bench.
Eight gigabytes a slot is a modest building block, so the arithmetic is worth doing before the cart. Eight slots gives 64 GB, twelve gives 96 GB, sixteen gives 128 GB and twenty-four gives 192 GB, all at one module per channel and therefore one rank per channel. Doubling to two modules per channel doubles the capacity and takes the channel to two ranks, which at 2,133 is still inside every published limit.
The alternative is fewer, denser modules: sixteen slots of 32 GB reach 512 GB where sixteen of these reach 128 GB. Paying for density instead of count usually wins on a new build and loses on a repair, where one failed module out of sixteen is a much cheaper event than one out of four.
2,133 is the floor of the DDR4 range, so this module is accepted almost everywhere DDR4 registered memory is accepted, and in each case the channel adopts the slowest module present. Put one in a channel rated 2,400 or 2,666 and the whole channel drops to 2,133 without an error message; the drop shows in a benchmark or a firmware log, not on the screen.
Generations do not mix at all. DDR3 uses a different notch and different signalling and no adapter bridges the two, and DDR5 sits in a different keying again. Registered and unbuffered are equally exclusive: the register exists to buffer a bus that an unbuffered module drives directly, and the board is wired for one or the other.
Within DDR4 the pairings on this page are gentler than usual, because every 8 GB build of this speed is single or double rank and the arithmetic is easy: two 1Rx8 modules per channel is two ranks, one 1Rx8 plus one 2Rx8 is three, and three is the number that leaves the published tables. Matching revision and speed inside a channel costs nothing and removes the question.
DDR4-2133 belongs to the first server generation that used DDR4 at all, and later parts accept it at a derate. Three catalogue pages are the closest neighbours:
None of the three refuses the module. The clock, not the compatibility, is what changes, and it changes for the whole channel rather than for the module.
The catalogue code M393A1K43BB0 fixes family, device width and revision; CPB carries the 2,133 speed block and the component generation; what follows is a build suffix of one to three characters. The eight suffixes below are not uniform in length, which is the one thing worth noticing about this list — quote the code as printed and do not trim it to two characters by habit.
| Code | Type | Build tail | Condition | Quote |
|---|---|---|---|---|
| M393A1K43BB0 | Catalogue code | Family code without a speed block; the P build listed here is the PC4-17000 / 2,133 MT/s one | New / used | Enquire |
| M393A1K43BB0-CPB | Ordering code | Base code, no suffix appended | New / used | Enquire |
| M393A1K43BB0-CPB0 | Ordering code | 0 — one character | New / used | Enquire |
| M393A1K43BB0-CPB00 | Ordering code | 00 — two characters | New / used | Enquire |
| M393A1K43BB0-CPB0Q | Ordering code | 0Q | New / used | Enquire |
| M393A1K43BB0-CPB0QS | Ordering code | 0QS — three characters | New / used | Enquire |
| M393A1K43BB0-CPB20 | Ordering code | 20 | New / used | Enquire |
| M393A1K43BB0-CPB2Q | Ordering code | 2Q | New / used | Enquire |
| M393A1K43BB0-CPBQ | Ordering code | Q — one character | New / used | Enquire |
Every module leaves with one year of cover from the dispatch date, new or pulled, recorded against the part number and the batch, so a claim does not hinge on an invoice still existing. Pulled units are tested as a matched set before packing and the sheet travels with the order. Stock in the warehouse ships in three to seven working days, tracking issued when it goes, minimum order two pieces.
There is no figure on this page on purpose. Two conditions, eight codes and a market that moves weekly would make a printed number wrong more often than right, so send the code, the quantity, the condition and the platform and the answer comes back the same working day.
Tell us who you are — we reply within one working day with a firm quote, stock status and lead time. Volume discounts available.
16 GB DDR4-2933 PC4-23400 ECC registered RDIMM, 2Rx8 on eighteen 8 Gb x8 packages, 1.2 V, 288-pin; six ordering codes under M393A2K43CB2-CVF with BY, CO, BQ, C0 and GQ tails
16 GB DDR4-2400 PC4-19200 ECC registered RDIMM, 2Rx8 on eighteen 8 Gb x8 packages, 1.2 V, 288-pin; eighteen ordering codes under the M393A2K43BB1 and M393A2K43CB1 revisions
16 GB DDR4-2133 PC4-17000 ECC registered RDIMM, 2Rx8 on eighteen 8 Gb x8 packages, 1.2 V, 288-pin; nine ordering codes from M393A2K43BB1-CPB through the CPBQ tail
16 GB DDR4-2666 PC4-21300 ECC registered RDIMM, 2Rx8 on eighteen 8 Gb x8 packages, 1.2 V, 288-pin; six ordering codes under M393A2K43BB1-CTD with 6Q, 6Y, 7Q, 7Y and 8Q tails