16 GB DDR4-2666 PC4-21300 ECC registered RDIMM, 2Rx4, 1.2 V, 288-pin; four ordering codes issued at 2,666: M393A2G40EB2-CTD and its 6Q, 7Q and 8Q suffixes
| Capacity | 16 GB |
|---|---|
| Memory Type | DDR4 |
| Speed | 2666 MT/s |
| Form Factor | RDIMM |
| Rank | 2Rx4 |
| ECC | ECC |
| Voltage | 1.2 V |
| Module Height | Standard |
| Condition | New · Used |
Samsung 16 GB DDR4-2666 ECC registered RDIMM at standard height, two ranks of x4 devices on a 288-pin board at 1.2 V. PC4-21300 at CAS latency 19, 14.25 ns at the 1,333 MHz clock, and 21.3 GB/s peak per 64-bit channel.
This is the density the second Scalable generation settled on: sixteen gigabytes per slot at 2,666 is 128 GB across eight channels with one module each, which is the configuration most of these machines shipped with. It is also the combination where the rank budget and the clock pull hardest against each other, and that is what most of this page is about.
Four ordering codes carry it, one base and three suffixes, and they are in a table at the foot of the page.
| Part number | M393A2G40EB2-CTD, with the four ordering codes listed under Ordering codes (catalogue code M393A2G40EB2) |
|---|---|
| Capacity | 16 GB per module, single module |
| Organisation | 2Rx4 — two ranks of eighteen x4 devices, thirty-six 4 Gb packages, 144 Gb of silicon for 128 Gb of data plus its check bits |
| Speed | DDR4-2666, PC4-21300, 2,666 MT/s, 21.3 GB/s peak per 64-bit channel |
| Timings | CL19 at 1,333 MHz, 14.25 ns; JEDEC 2666V bin |
| Voltage | 1.2 V nominal |
| Form factor | 288-pin RDIMM at standard height, 31.25 mm, bare PCB with no heatspreader |
| Register | On-module register buffers the command and address bus, so the module needs a controller that supports registered memory |
| Error handling | ECC across the 64-bit data path, plus parity on the registered command and address path |
| Manufacture | Samsung; assembly site and date code vary by production run and are printed on the module, not fixed by the part number |
| Condition | New and tested pulls, both stocked |
The part number is one line and it carries every field that decides compatibility. Date code and revision letters sit outside that line and describe the batch instead. The table below keeps them apart.
| Printed as | Means | Why it decides a purchase |
|---|---|---|
| M393 | Standard-height registered module | The 31.25 mm default; the low-profile equivalent carries M392 and eleven millimetres less board |
| 16GB | Capacity of this one module | One per channel on an eight-channel board is 128 GB, the baseline this part was built for |
| 2Rx4 | Two ranks, x4 device width | Two ranks against a channel budget, and at two modules per channel that budget is four |
| PC4-21300V | DDR4-2666, bin V, which is CL19 | The letter fixes the timing grade; without it a listing has stated a clock and left latency unstated |
| -R | Registered, not unbuffered | Electrically different from an unbuffered module of the same capacity, and it will not train in that board |
| EB2 | Die generation and raw card revision | Records which silicon and which raw card the board came from; it changes nothing upstream of it |
| CTD6Q … CTD8Q | Two-character ordering suffix | What a purchase order quotes, and the only variation across the four codes stocked |
| SPD revision | Two-digit JEDEC SPD revision | Conservative firmware reads early revisions low, which appears as a derate rather than a failure |
| YYWW | Date code, year and week | The only service history a pull carries, and the first thing to read when judging remaining life |
2,666 arrived with the Scalable refresh and stayed the default for that whole platform generation. Against the 2,400 grade the arithmetic is undramatic: 21.3 GB/s against 19.2, roughly eleven per cent, with absolute latency essentially level at 14.25 ns against 14.17. What made it the default was not any single benchmark but that the platform rated it, so the memory stopped being the thing that limited the build.
Sixteen gigabytes per slot is where the two numbers meet. At one module per channel, eight channels give 128 GB and twelve give 192 GB, all at label speed and all inside the published rank tables. Going to two modules per channel doubles the capacity and is where the next section starts.
A 2Rx4 module puts two ranks on the channel, so two modules per channel is four. Every guide allows four ranks at 2,666 on paper, and a good number of boards do not hold the clock there in practice: they ease to 2,400, occasionally to 2,133, and report nothing. The wider the clock, the thinner the window in which the controller can still close timing across four ranks of thirty-six packages each.
So the population decision comes before the purchase decision. If the build is one module per channel, this grade delivers everything it promises. If every slot is going to be filled, the honest expectation is 2,400, and a 2,400 part would have cost less for the same result. The document that settles it is the platform's rank and population table, not this page.
The middle path is worth knowing: fill half the channels with two modules and leave the others at one. That keeps every channel at or below the rank count where the clock survives, at the cost of an asymmetric layout, which some NUMA-aware workloads notice and most do not.
Speed settles to the slowest module in the channel, silently. Putting one 2,400 module among these takes the channel to 2,400 and no operating system reports it. Given that the reason for buying this grade is the clock, a mixed channel usually means the premium was spent and not collected.
Rank is the harder budget. Two of these per channel is four ranks and legal; adding a single-rank module makes five and leaves the tables. Capacity can vary inside a channel without consequence, rank cannot, and revision does not constrain anything at all: EB1 and EB2 are successive component generations of one design and a channel holding one of each runs as designed.
Generation and buffering are exclusions rather than preferences. DDR3 does not key into the slot, DDR5 uses a different notch, and an unbuffered module is the wrong electrical interface for a registered board however similar it looks.
DDR4-2666 is native to the second Scalable generation, and accepted at a derate by later parts. Three catalogue pages mark the cases:
In each case the module fits and the clock is its own. The part number describes the module, not the machine.
Four codes carry this module: the base and three two-character suffixes. M393A2G40EB2 fixes height class, density, device width and revision, CTD is the 2,666 speed block, and the last two characters are what the paperwork names. Only three suffixes were issued at this speed, which makes the list short enough to check by eye at goods-in.
| Code | Type | Build tail | Condition | Quote |
|---|---|---|---|---|
| M393A2G40EB2 | Catalogue code | Family code without a speed block; the V build listed here is the PC4-21300 / 2,666 MT/s one | New / used | Enquire |
| M393A2G40EB2-CTD | Ordering code | Base code, no suffix appended | New / used | Enquire |
| M393A2G40EB2-CTD6Q | Ordering code | 6Q | New / used | Enquire |
| M393A2G40EB2-CTD7Q | Ordering code | 7Q | New / used | Enquire |
| M393A2G40EB2-CTD8Q | Ordering code | 8Q | New / used | Enquire |
Cover is one year from dispatch on new stock and on tested pulls alike, recorded against the part number and the batch so a claim survives a lost invoice. Pulled modules are checked in matched sets before packing and the test sheet travels with the order. Warehouse stock ships in three to seven working days with tracking at dispatch, and the minimum order is two pieces.
No price is printed because the line is quoted. Two conditions, four codes and a per-piece figure that moves with quantity make a page number unreliable, so send the code, the quantity, the condition and the platform and the answer comes back the same working day.
Tell us who you are — we reply within one working day with a firm quote, stock status and lead time. Volume discounts available.
16 GB DDR4-2933 PC4-23400 ECC registered RDIMM, 2Rx8 on eighteen 8 Gb x8 packages, 1.2 V, 288-pin; six ordering codes under M393A2K43CB2-CVF with BY, CO, BQ, C0 and GQ tails
16 GB DDR4-2400 PC4-19200 ECC registered RDIMM, 2Rx8 on eighteen 8 Gb x8 packages, 1.2 V, 288-pin; eighteen ordering codes under the M393A2K43BB1 and M393A2K43CB1 revisions
16 GB DDR4-2133 PC4-17000 ECC registered RDIMM, 2Rx8 on eighteen 8 Gb x8 packages, 1.2 V, 288-pin; nine ordering codes from M393A2K43BB1-CPB through the CPBQ tail
16 GB DDR4-2666 PC4-21300 ECC registered RDIMM, 2Rx8 on eighteen 8 Gb x8 packages, 1.2 V, 288-pin; six ordering codes under M393A2K43BB1-CTD with 6Q, 6Y, 7Q, 7Y and 8Q tails