8 GB DDR4-2400 PC4-19200 ECC registered RDIMM, 1Rx8, 1.2 V, 288-pin; nine ordering codes from M393A1K43BB0-CRC00 to -CRC4Y
| Capacity | 8 GB |
|---|---|
| Memory Type | DDR4 |
| Speed | 2400 MT/s |
| Form Factor | RDIMM |
| Rank | 1Rx8 |
| ECC | ECC |
| Voltage | 1.2 V |
| Module Height | Standard |
| Condition | New · Used |
Samsung 8 GB DDR4-2400 ECC registered RDIMM, a single rank of x8 devices on a standard 288-pin registered module at 1.2 V. Rated PC4-19200 with CAS latency 17, 14.17 ns at the 1,200 MHz clock, and 19.2 GB/s peak per 64-bit channel.
This is the lightest 8 GB DDR4-2400 module Samsung built: one rank, nine devices. Reaching 8 GB with nine x8 devices means 8 Gb components, where the two-rank variants of the same capacity use eighteen 4 Gb devices instead. Same capacity, same speed, same slot, and a materially different load on the memory controller — which is why it is a separate page from the 1Rx4 and 2Rx8 builds in the catalogue.
Every code in the table below is the same 8 GB 1Rx8 module at 2,400 MT/s. The block before the dash fixes family, device width and die revision; the dash and its tail are what a purchase order or an invoice actually names, and Samsung publishes no public decoder for them.
| Part number | M393A1K43BB0-CRC, with the nine ordering codes listed under Ordering codes (catalogue code M393A1K43BB0) |
|---|---|
| Capacity | 8 GB per module, single module |
| Organisation | 1Rx8 — one rank of x8 devices, nine devices for the 72-bit path, eight for data and one for the check bits, on 8 Gb components |
| Speed | DDR4-2400, PC4-19200, 2,400 MT/s, 19.2 GB/s peak per 64-bit channel |
| Timings | CL17 at 1,200 MHz, 14.17 ns; JEDEC 2400T bin |
| Voltage | 1.2 V nominal |
| Form factor | 288-pin RDIMM, standard height 31.25 mm, bare PCB with no heatspreader |
| Register | On-module register buffers the command and address bus, so the module needs a controller that supports registered memory |
| Error handling | ECC across the 64-bit data path, plus parity on the registered command and address path |
| Manufacture | Samsung; assembly site and date code vary by production run and are printed on the module, not fixed by the part number |
| Condition | New and tested pulls, both stocked |
Three fields on this label come from the part number: capacity, the 1Rx8 organisation and the PC4-19200 bin, whose T letter fixes CL17. The rest describe the run it came from — revision letters, SPD level and the YYWW date all move between runs — so they are decoded below rather than printed as facts.
| Printed as | Means | Why it decides a purchase |
|---|---|---|
| 8GB | Capacity of this one module | Sets how many slots are needed for the target memory size, and it is the one number a platform setting cannot change |
| 1Rx8 | Single rank, x8 device width | One rank of nine devices is the lightest load a channel can carry, so this module is the one that survives a full population at the rated speed |
| PC4-2400T | DDR4-2400, JEDEC bin T, which is CL17 | The bin letter is the timing grade, not a vendor code; a listing that says PC4-2400 without the letter has not specified latency |
| -R | Registered, not unbuffered | An unbuffered module of the same capacity looks similar from above and will not post in a registered-only board |
| BB0 | Die and raw card revision | Same capacity, rank and speed as the neighbouring revisions; it records which component generation the module was built from |
| CRC00 … CRC4Y | Ordering tail, the last two characters of the code | The field a BOM or an invoice names. It does not change capacity, rank or speed, all of which are fixed earlier in the code |
| SPD revision | Two-digit JEDEC SPD revision level | Older firmware reads lower revisions more reliably; this generation is old enough that the difference still shows up |
| YYWW | Date code, year and week | Age of the stock; on pulls it is the first evidence of how long the module has been in service |
A rank is a bank of devices addressed together and its width is fixed at 72 bits: 64 for data and 8 for ECC. Nine x8 devices fill one rank exactly, so eight gigabytes in a single rank means each device holds 8 Gb. The other two 8 GB builds at this speed use eighteen 4 Gb devices — as one rank of x4, or as two ranks of x8 — and the difference is what the memory controller has to drive.
Three things follow from one rank and nine devices. The data bus sees the least capacitance of any 8 GB option, so a channel filled with these keeps its rated clock longer. The controller is not spending setup time switching between ranks. And the ranks-per-channel budget goes further: two of these per channel is two ranks, where two 2Rx8 modules would be four.
The trade is die density. An 8 Gb x8 device is a later component than the 4 Gb parts behind the two-rank builds, which is why this module is the one to specify when a machine has to run at 2,400 with every slot populated, and why it is not the cheapest 8 GB part on the market.
Eight gigabytes per slot at 2,400 is the middle of the DDR4 range. One module per channel on an eight-slot board is 64 GB, twelve slots is 96 GB, sixteen is 128 GB and twenty-four is 192 GB, and because each module is a single rank, two modules per channel still leaves the channel at four ranks or fewer on most boards — the population where 2,400 usually survives.
It is also the like-for-like replacement. Where a machine was populated with 8 GB 1Rx8 modules at 2,400, matching capacity, rank and revision keeps the channel uniform; a 2Rx8 part of the same capacity would add a rank the firmware is not expecting.
Count the slots before choosing a module: an 8 GB 1Rx8 population at 2,400 gives 64 GB across eight slots, 96 GB at twelve, 128 GB at sixteen and 192 GB at twenty-four. The same sixteen slots filled with 32 GB parts is 512 GB — this module is the balanced line, not the dense one.
Generation and signal type come first — DDR3 does not fit, unbuffered does not post in a registered board, DDR5 uses another notch — and only then do the variables matter: for this 2,400 1Rx8 module they are capacity, rank and the clock the host applies.
The trap here is 8 GB modules that look interchangeable and are not. Three geometries exist at this capacity and speed: one rank of nine x8 devices, two ranks of nine x8 devices, and one rank of eighteen x4 devices. All three post in the same board; only the first keeps a full channel at the rated clock, and mixing them inside one channel puts the channel on the timing of the heaviest module.
Speed is the quieter variable. Drop a 2,400 1Rx8 module among faster parts and the channel simply runs at the slower bin, with nothing in the log to announce it. Matched modules per channel, then a second matched set, keeps rank, revision and speed uniform.
This clock sits in the middle of the DDR4 range: native to the first two Scalable generations, tolerated by everything above them. The pages that pair with this 1Rx8 build:
Compatibility is not the question with this 2,400 1Rx8 part — clock and population are. Treat the 2,400 figure as the module's ceiling and the platform guide as the authority on what it will run at.
| Code | Type | Build tail | Condition | Quote |
|---|---|---|---|---|
| M393A1K43BB0 | Catalogue code | Family code without a speed block; the T build listed here is the PC4-19200 / 2,400 MT/s one | New / used | Enquire |
| M393A1K43BB0-CRC | Ordering code | Base ordering code, tail not appended | New / used | Enquire |
| M393A1K43BB0-CRC00 | Ordering code | 00 | New / used | Enquire |
| M393A1K43BB0-CRC0Q | Ordering code | 0Q | New / used | Enquire |
| M393A1K43BB0-CRC0Y | Ordering code | 0Y | New / used | Enquire |
| M393A1K43BB0-CRC30 | Ordering code | 30 | New / used | Enquire |
| M393A1K43BB0-CRC3Q | Ordering code | 3Q | New / used | Enquire |
| M393A1K43BB0-CRC40 | Ordering code | 40 | New / used | Enquire |
| M393A1K43BB0-CRC4Q | Ordering code | 4Q | New / used | Enquire |
| M393A1K43BB0-CRC4Y | Ordering code | 4Y | New / used | Enquire |
The M393A1K43BB0-CRC line carries one year of cover from dispatch, new or pulled, recorded per part number and batch. Every pull is tested as a matched set before packing and that result ships with the module; orders leave in three to seven working days, two pieces minimum.
Pricing here is per enquiry, not per page. Send the exact 2,400 1Rx8 code, the quantity and the platform and the answer arrives the same working day; a set quote beats piecemeal orders because the channel population can be validated first.
Tell us who you are — we reply within one working day with a firm quote, stock status and lead time. Volume discounts available.
16 GB DDR4-2933 PC4-23400 ECC registered RDIMM, 2Rx8 on eighteen 8 Gb x8 packages, 1.2 V, 288-pin; six ordering codes under M393A2K43CB2-CVF with BY, CO, BQ, C0 and GQ tails
16 GB DDR4-2400 PC4-19200 ECC registered RDIMM, 2Rx8 on eighteen 8 Gb x8 packages, 1.2 V, 288-pin; eighteen ordering codes under the M393A2K43BB1 and M393A2K43CB1 revisions
16 GB DDR4-2133 PC4-17000 ECC registered RDIMM, 2Rx8 on eighteen 8 Gb x8 packages, 1.2 V, 288-pin; nine ordering codes from M393A2K43BB1-CPB through the CPBQ tail
16 GB DDR4-2666 PC4-21300 ECC registered RDIMM, 2Rx8 on eighteen 8 Gb x8 packages, 1.2 V, 288-pin; six ordering codes under M393A2K43BB1-CTD with 6Q, 6Y, 7Q, 7Y and 8Q tails